Canfiti for the Infiniti QX80 and QX56 (Z62)
On the second-generation QX56 and QX80 Canfiti does the most: all six units, from tire pressure sensors to the cruise control radar. The app’s author drives both Nissan and Infiniti cars himself and tests features on his own vehicles.
- QX56 Z62 — 2011–2013, QX80 Z62 — 2014–2024
- VK56VD engine, Jatco JR711E transmission
- The new 2025+ QX80 is a different generation
What Canfiti does for this model
-
Tyre pressure sensors
Sensor registration after a wheel swap and live pressure in every wheel.
TPMS sensors -
Hidden settings
DRL, one-touch lane change signal, headlamp washer, rain sensor, drip wipe, BCM code for keys.
Hidden BCM settings -
Air suspension
Compressor and valve tests, live ride height, standard height calibration after a sensor or strut replacement.
Air suspension -
Transmission diagnostics
86 JR711E parameters: fluid temperature, gears, torque converter slip, solenoids.
Transmission -
Engine
Misfires for all 8 cylinders with a bank diagram, fuel trims, fuel pressure.
Engine -
ADAS and cruise control
Data Monitor for Intelligent Cruise Control and driver assistance — on radar-equipped QX80s.
ADAS & cruise
Guides for this model
- 7 min Nissan and Infiniti TPMS Relearn: Register Tire Sensors Yourself Put on a second set of wheels and the TPMS light won't go out? You can register the sensors yourself in a few minutes with a phone running Canfiti, an ELM327 adapter and a TPMS activator.
- 8 min Infiniti QX80 Transmission Temperature and JR711E Live Data with ELM327 The JR711E is a tough transmission, but early wear only shows up in the numbers. Here are the six readings to check first and a 15-minute health check you can run with your phone.
- 6 min One-Touch Lane Change Signal on Nissan Patrol Y62 and Infiniti QX56 Tap the stalk to the first click and the turn signal flashes three times, then cancels itself. On the Patrol Y62 and QX56 it’s a single BCM setting you can switch on in the Canfiti app.
- 6 min Infiniti QX80 and QX56 Rear Air Suspension Height Calibration with ELM327 New height sensor, struts or control unit, and now the rear rides too high or sags? You can store the standard ride height again yourself with an ELM327, a phone, and a lift or a jack.
- 7 min Nissan Patrol Y62 and Infiniti QX56 DRL Activation Without Wiring On the Patrol Y62 and QX56, daytime running lights are a BCM setting: fog lamps, low beams, or LEDs can do the job. All you need is an ELM327 adapter and the Canfiti app.
- 6 min How to Disable the Headlamp Washer on Infiniti QX56 and Nissan Patrol The headlamp washers can be switched off entirely or set to a shorter or longer spray — it’s a BCM setting. No need to pull a fuse, and you can undo it in a minute.
- 6 min Per-Cylinder Misfire Counts and Fuel Trims on Infiniti and Nissan with ELM327 Canfiti shows a misfire counter for every cylinder, fuel trims for each bank, and fuel pressure. Here’s how to read those numbers and when it’s time to look at a plug or a coil.
- 7 min How to Disable the Rain Sensor on Infiniti QX80, QX56 and Nissan Patrol If your wipers stopped pausing after a windshield replacement, you can switch the rain sensor off in software and get adjustable intermittent wipes back. Plus two handy wiper settings hidden in the BCM.
Questions and answers
Does Canfiti work with the 2025 Infiniti QX80?
No, the 2025+ QX80 is a new generation with different units. Canfiti is verified on the 2014–2024 QX80 and 2011–2013 QX56 (Z62).
Can I calibrate the QX80 air suspension without the dealer?
Yes, in the “E-SUS unit” section. Step-by-step calibration.
Does the QX80 have DRL from the factory?
Yes, DRL is enabled on the QX80 from the factory. In “DTLR Mode” you can choose fog lamps, low beam or LED.
Which adapter should I get for a QX80?
Any ELM327 with BLE works with both iPhone and Android. How to choose an adapter.